Did you know that 60% of our customers re-order in our shop?

The MK2  is only available on pre-order (lead time approximately 1 month) - minimum order quantity: 10 pieces.

The MK2 is an Arduino compatible board that is based on the Atmega328P.

It has an onboard RFM69W/RFM69HW transceiver but you can also order it without the transceiver.

You can order the MK2 with a u.FL connector to connect it to an external antenna via a cable, or you can just use the supplied straight wire antenna.

Find out more about the MK2

What you get with this product:

  • Canique MK2 board with soldered onboard RFM69 transceiver (if ordered)
  • If RFM69 is included: a straight wire antenna of 8.6cm (868MHz) / 17.3cm (433MHz) length. Wire antenna is packaged separately. Not soldered.
  • 1x right angle 6 pin Header for the FTDI port, 2x straight 13 pin Headers for the output and input pins. Pin headers are packaged separately. Not soldered.

Write a review

Please login or register to review

Canique MK2

  • Brand: Canique
  • Product Code: MK2
  • Availability: Pre-Order
  • 13.90€

Available Options

This product has a minimum quantity of 10

Related Products

Canique Boost

Canique Boost

Converts an input voltage starting at 0.8V to a higher voltage - output voltages of 2.4 to 5V are av..




The RFM69HW is a radio transceiver used in our Canique MK2.It can achieve 1km range with a straight ..


Winbond W25X40CLSNIG Flash Memory

Winbond W25X40CLSNIG Flash Memory

The W25X40CLSNIG 4 MBit flash memory is used in our Canique MK2/MK3e etc.It's available in our shop ..


Solder Pins Service for MK2/MK3e

Solder Pins Service for MK2/MK3e

This product is an additional service:If you order an MK2/MK3e you can add this service in case you ..


Tags: Atmega328P, Arduino, Arduino RFM69W, Arduino RFM69HW, Moteino clone